Cisco UCS B200 M5

the following URL: http://www.cisco.com/en/US/products/ps10281/products_installation_and_configuration_
guides_list.html
If you need to move a RAID cluster, see the Cisco UCS Manager Troubleshooting Reference Guide.
Removing a Blade Server Cover
To remove the cover of the blade server, follow these steps:
Procedure
Step 1
Press and hold the button down as shown in the figure below.
Step 2
While holding the back end of the cover, pull the cover back and then up.
Figure 4: Removing the Cover of the Blade Server
Cisco UCS B200 M5 Blade Server Installation and Service Note
13
Servicing a Blade Server
Removing a Blade Server Cover