Do you have a question about the Cisco UCS B200 and is the answer not in the manual?
Form Factor | Blade |
---|---|
Storage | Up to 2 x 200GB SSDs or 2 x 300GB SAS drives |
Power Supply | Part of Cisco UCS Blade Server Chassis |
Management | Cisco UCS Manager |
Storage Controller | Cisco UCS Virtual Interface Card (VIC) |
Summarizes the meaning of various blade server LED indicators.
Details the purpose and usage of the reset and power buttons.
Describes the KVM cable and its connectors for blade server access.
Explains the meaning of warning, caution, and note symbols used in the document.
Step-by-step guide for installing a hard drive into a blade server.
Step-by-step guide for removing a hard drive from a blade server.
Procedures for safely shutting down and powering off the blade server.
Steps to physically remove a blade server from its chassis.
Steps to physically install a blade server into its chassis.
Instructions for removing the top cover of the blade server.
Guidance on installing air baffles for proper server cooling.
Explains the functionality of the diagnostic button and related LEDs.
Procedure for installing or replacing the motherboard CMOS battery.
Lists available CPU options and provides CPU replacement steps.
Step-by-step instructions for removing the CPU and heat sink.
Detailed steps for installing DIMMs into the blade server memory slots.
Lists of Cisco-supported DIMMs for M1 and M2 server models.
Explains BIOS settings for low-voltage DIMMs and power modes.
Describes the physical arrangement of DIMM slots and memory channels.
Discusses factors affecting blade server memory performance.
Recommendations for achieving optimal memory bandwidth and performance.
Details memory mirroring and Reliability, Availability, Serviceability features.
Information on accessing Cisco documentation and submitting service requests.