To Next PageTo Next Page
Need help?Do you have a question about the Cisco Nexus 7010 and is the answer not in the manual?
General| Product Series | Nexus 7000 |
|---|---|
| Model | 7010 |
| Product Type | Modular Switch |
| Slots | 10 |
| Switching Capacity | Up to 15 Tbps |
| Operating System | Cisco NX-OS |
| Virtualization Support | Yes |
| Port Density | Up to 384 10G ports or 96 40G ports |
| Power Supply Options | 3000W AC, 3000W DC |
| Layer Support | Layer 2 and Layer 3 |
| Management Interfaces | CLI, SNMP |
| Redundancy | Yes (N+1) |
Outlines the essential site preparation steps required before installing the Cisco Nexus 7000 Series system.
Details critical safety instructions and precautions for handling and installing the equipment.
Explains how to properly ground the Cisco Nexus 7009 system for safety and EMI compliance.
Explains the grounding process for the Cisco Nexus 7010 system for safety.
Covers initial preparations before installing the Cisco Nexus 7018 chassis.
Details the procedure for attaching bottom-support rails for the Cisco Nexus 7018 chassis.
Provides instructions for physically installing the Cisco Nexus 7018 chassis into a rack.
Explains the grounding process for the Cisco Nexus 7018 system.
Describes how to install AC and DC power supply units in Cisco Nexus 7000 Series chassis.
Guides on connecting AC power supply units to facility AC power sources.
Details the process of connecting DC power supply units to DC power sources.
Explains how to establish a local management connection via the console port.
Guides on performing the initial IP address and password configuration.
Describes how to configure the management interface for out-of-band access.
Details connecting the CMP port for secondary network interface access.
Covers connecting copper and fiber-optic I/O modules to the network.
Shows how to display FRU information, including product IDs and serial numbers.
Explains how to obtain the switch's serial number using CLI commands.
Describes how to display actual power usage for the switch and its modules.
Explains different power modes like Combined, Redundancy, and Input Source Redundancy.
Guides on checking the operational status of all switch modules.
Provides initial steps and overview for troubleshooting Cisco Nexus 7000 Series hardware.
Details troubleshooting steps for fan tray module issues indicated by LEDs.
Guides on troubleshooting AC power supply unit problems based on LED status.
Covers troubleshooting DC power supply unit issues indicated by LEDs.
Details troubleshooting steps for supervisor module problems indicated by LEDs.
Outlines troubleshooting steps for fabric module hardware issues.
Guides on replacing AC power supply units while the system is operating.
Details the procedure for replacing DC power supply units during system operations.
Covers replacing supervisor modules, including single and dual supervisor systems.
