To Next PageTo Next Page
Need help?Do you have a question about the Cisco Nexus 9516 and is the answer not in the manual?
General| Model | 9516 |
|---|---|
| Product Type | Switch |
| Form Factor | Chassis |
| Total Slots | 16 |
| Switching Capacity | 60 Tbps |
| Operating System | Cisco NX-OS |
| Product Series | Nexus |
| Redundancy | N+1 |
| Cooling | Front-to-back airflow |
| Management | CLI, SNMP |
| Supported Modules | Various Nexus modules supported |
Provides an overview of the switch and its modular components like supervisors, controllers, line cards, and fabric modules.
Specifies the required operating and non-operating temperature and humidity ranges for the switch.
Outlines operational altitude limits and precautions for dust, EMI, and RFI.
Explains grounding procedures and guides power requirement planning for the switch.
Specifies the requirements for racks, cabinets, and clearances for proper switch installation.
Instructions for preparing and installing the rack or cabinet for the chassis installation.
Guidance on inspecting the new switch and installing bottom-support rails.
Procedure for physically installing the switch chassis into a rack and grounding it.
Instructions for powering on and starting the switch after installation.
Best practices for connecting network cables and transceivers to ports.
Steps for establishing console and management port connections for configuration.
Guide to performing the initial configuration, including IP addressing and network setup.
Instructions for connecting copper (BASE-T) and optical interface ports to network devices.
Guidelines for maintaining transceivers and optical cables for optimal performance.
How to display information about installed hardware modules and switch inventory.
How to display the status, temperatures, and environmental information of switch modules.
Procedures for shutting down, starting up, reloading modules, and saving configurations.
Details about supervisor modules, power modes, and fan tray operations.
Essential steps to prevent electrostatic discharge when handling switch components.
Detailed instructions for installing or replacing supervisor and system controller modules.
Procedures for installing or replacing line cards and fan trays in the chassis.
Instructions for replacing fabric modules and installing or replacing power supply units.
Steps for upgrading line cards and fabric modules to newer 100-Gigabit versions.
Details ambient operating limits, dimensions, and weights of the switch and its components.
Details power specifications for supplies and requirements based on configuration modes.
Describes the status and meaning of chassis and system controller module indicator LEDs.
Explains the LEDs for supervisor, fan tray, and fabric modules indicating operational status.
Details the LEDs for line cards and power supply modules, including status and fault indicators.
Lists the contents of the accessory kit provided with the switch, such as cables and mounting hardware.
