Step 8 Align the mounting bracket on the chassis to the vertical mounting rails on the rack, and attach the chassis to the rack.
Align the screw holes in the chassis mounting brackets to the screw holes in the vertical mounting rails on the rack or
cabinet. Use a Phillips screwdriver to screw in four M6 x 19-mm or 12-24 x 3/4-inch screws in each of the two chassis
mounting brackets (use a total of eight screws for two mounting brackets). See the following figure.
To adjust the placement of the chassis on the bottom-support rails, use the chassis handles.
Tip
Four M6 x 19 mm or 10-24
x 3/4 in. Phillips screws that
are used to attach each side
bracket to a front mounting
rail (use a total of eight
screws).
2Handles used to adjust the
chassis placement.
1
Step 9 To reinstall the fabric modules, see Installing a Fabric Module, on page 78
Step 10 To reinstall the fan trays, see t_n95xx_install_fan_tray.xml
What to do next
After the chassis is secured to the rack, you can ground the switch (see Grounding the Chassis, on page 27).
Cisco Nexus 9516 NX-OS Mode Switch Hardware Installation Guide
26
Installing a Chassis
Installing a Chassis in a Rack or Cabinet
To Next Page
Loading...
