Cisco Nexus 9516 - Fabric Module Leds; Line Card Leds

Fabric Module LEDs
The fabric modules are located behind the fan trays. The following table describes the possible states for each
of these LEDs.
StatusColorLED
The operator has activated this beacon (BCN) LED to identify this module
in the chassis.
When the operator activates the BCN/top LED, the BCN LED
on the covering fan module also activates (lights).
Note
BlueBCN/top
LED
This module is not being identified.Off
The fabric module is operational.
GreenStatus/bottom
LED
The fabric module has a fault.Flashing red
The fabric module is booting up.Flashing amber
No power is going to the fabric module.Off
Line Card LEDs
The Beacon (BCN) and Status (STS) LEDs are located on the front, toward the left side of the module. The
Link LED for each port is located between the two rows of ports. Each of the Link LEDs is a triangle pointing
to the port above or below the LED. The following table describes the possible states for each of these LEDs.
StatusColorLED
The operator has activated this LED to identify this module in the
chassis.
Flashing blueBCN
This LED is not being used.Off
Cisco Nexus 9516 NX-OS Mode Switch Hardware Installation Guide
108
LEDs
Fabric Module LEDs