To Next PageTo Next Page
Need help?Do you have a question about the Cisco Nexus 93180YC-FX and is the answer not in the manual?
General| Switching Capacity | 3.6 Tbps |
|---|---|
| Rack Units | 1 RU |
| Jumbo Frame Support | 9216 bytes |
| Product Series | Nexus 9000 |
| Model | 93180YC-FX |
| Operating System | Cisco NX-OS |
| Memory | 16 GB |
| Storage | 64 GB SSD |
| VLANs | 4096 |
| Ports | 48 x 25 Gigabit Ethernet / 10 Gigabit Ethernet SFP28/SFP+ + 6 x 40/100 Gigabit Ethernet QSFP28 |
| Airflow | Back to front |
| Power Supply | 930 W DC |
| Routing Protocol | BGP, OSPF, EIGRP, IS-IS, PIM |
| Remote Management Protocol | SNMP, Telnet, SSH, HTTP/HTTPS |
| Features | VXLAN |
| Compliant Standards | IEEE 802.1Q, IEEE 802.1p |
| Latency | Sub-microsecond |
General introduction to the Cisco Nexus 93180YC-FX switch and its components.
Explains the importance of grounding and provides methods for chassis connection.
Details power supply options and redundancy considerations for switch installation.
Describes airflow direction, module identification, and placement for cooling.
Lists suitable rack/cabinet types and general mounting requirements for the switch.
Specifies minimum clearances needed for switch installation, cabling, and airflow.
Provides important safety instructions and warnings prior to switch installation.
Details available rack-mount kits and types of racks/cabinets for installation.
Outlines general guidelines for switch installation, including clearance and grounding.
Step-by-step guide for installing the switch using the NXK-ACC-KIT-1RU.
Step-by-step guide for installing the switch using the N3K-C3064-ACC-KIT.
Procedures for properly grounding the switch chassis for safety.
Instructions for connecting power and turning on the switch after installation.
Procedure for replacing a fan module while the switch is operating.
Procedure for replacing AC, HVAC/HVDC, and DC power supply modules.
Details typical and maximum power consumption and heat dissipation for the switch.
