Cisco Nexus 9516 - Displaying Temperatures for a Module

DescriptionLine Card State
The switch detects insufficient power for a line card to power up.power-denied
This module is the active supervisor or system controller module and the switch is
ready to be configured.
active
The HA switchover mechanism is enabled on the standby supervisor module.HA-standby
The switchover mechanism is enabled on the standby system controller module.standby
Use the show module [slot_number] command to display information about all the installed modules or for
the module that you specify by its slot number.
This example shows how to display information about a module in a specific slot (slot 4) of the chassis.
Note
switch# show module 4
Mod Ports Module-Type Model Status
--- ----- ----------------------------------- ------------------ ----------
4 36 36p 40G Ethernet Module N9k-X9636PQ ok
Mod Sw Hw
--- -------------- ------
4 6.1(4.11) 0.1010
Mod MAC-Address(es) Serial-Num
--- -------------------------------------- ----------
4 00-22-bd-f8-2a-83 to 00-22-bd-f8-2a-b6 SAL17257AHD
switch#
Displaying Temperatures for a Module
You can display temperature readings for module temperature sensors by using the show environment
temperature command. System controllers, supervisors, line cards, and fabric modules have temperature
sensors with two thresholds:
• Minor temperature threshold—When a minor threshold is exceeded, a minor alarm occurs and the
following actions occur for all four sensors:
• Displays system messages
• Sends Call Home alerts (if configured)
• Sends SNMP notifications (if configured)
• Major temperature threshold—When a major threshold is exceeded, a major alarm occurs and the following
actions occur:
• For sensors 1, 3, and 4 (outlet and on-board sensors), the following actions occur:
• Displays system messages.
• Sends Call Home alerts (if configured).
Cisco Nexus 9516 NX-OS Mode Switch Hardware Installation Guide
45
Managing the Switch
Displaying Temperatures for a Module