Rack vertical mounting rails.3Push the sides of the lower
half of the front side of the
chassis (do not push or lift
any of the modules or
module handles).
1
Bottom-support rails4Chassis mounting brackets.2
Step 6 If the mechanical lift is raised above the bottom-support rails, gently lower the lift to the level of the brackets or no
more than 1/4 inch (0.6 cm) below the rails.
This action keeps the chassis level on the rails and helps prevent the chassis from getting caught on the inside edges of
the bottom-support rails.
Step 7 Use two people to push the chassis all the way onto the rack or cabinet.
You have pushed the chassis all the way when its two vertical mounting brackets come in contact with the vertical rails
on the rack or cabinet.
Cisco Nexus 9516 NX-OS Mode Switch Hardware Installation Guide
25
Installing a Chassis
Installing a Chassis in a Rack or Cabinet
To Next Page
Loading...
