Cisco 800 Series Configuring

Configuring Radio Settings on an Access Point
How to Configure Radio Settings on an Access Point
25
Configuring Packet Fragmentation Threshold on an Access Point
Perform this task to configure the size at which packets are fragmented (sent as several pieces instead of
as one block).
Use a low setting in areas where communication is poor or where there is a great deal of radio
interference.
SUMMARY STEPS
1. enable
2. configure terminal
3. interface dot11Radio interface
4. fragment-threshold bytes
5. end
6. copy running-config startup-config

Cisco 800 Series Specifications

General

Model	Cisco 800 Series
Category	Network Router
VPN Support	Yes
Firewall	Yes
Dimensions	Varies by model
Processor	Varies by model
Memory	Varies by model
Operating System	Cisco IOS
WAN Ports	Varies by model
LAN Ports	Varies by model
WAN Interfaces	Varies by model
LAN Interfaces	Fast Ethernet or Gigabit Ethernet