24
12 Checking the Access Point LEDs
The location of the access point status LED is shown in Figure 2.
Note Regarding LED status colors, it is expected that there will be small variations in color intensity
and hue from unit to unit. This is within the normal range of the LED manufacturer’s
specifications and is not a defect.
The access point status LED indicates various conditions and are described in Table 2.
13 Miscellaneous Usage and Configuration Guidelines
Using the Mode Button
Using the Mode button (see Figure 3) you can:
Table 2 LED Status Indications
Message Type LED State Message Meaning
Association status Green Normal operating condition, but no
wireless client associated
Blue Normal operating condition, at least one
wireless client association
Boot loader status Green Executing boot loader
Boot loader error Blinking Green Boot loader signing verification failure
Operating status Blinking Blue Software upgrade in progress
Alternating between Green
and Red
Discovery/join process in progress
Cycling through
Red-Off-Green-Off-Blue-Off
Access point location command invoked
from controller web interface.
Access point operating
system errors
Cycling through
Blue-Red-Green-Off
General warning; insufficient inline power
To Next Page
Loading...
