Need help?Do you have a question about the Cisco Aironet Wave 2 and is the answer not in the manual?
General| Category | Wireless Access Point |
|---|---|
| Wireless Standard | 802.11ac Wave 2 |
| Model | Aironet Wave 2 |
| Frequency Bands | 2.4 GHz, 5 GHz |
| Maximum Data Rate | 1.7 Gbps |
| MIMO Technology | MU-MIMO |
| MIMO | 4x4:4 |
| Power over Ethernet | Yes (802.3af/at) |
| Security | WPA2, WPA3, 802.1X, AES, TKIP |
| Management | Cisco DNA Center, Cisco Prime Infrastructure, WebUI, CLI |
| Operating Temperature | 0 to 40°C (32 to 104°F) |
| Mounting | Ceiling, wall, pole |
Details the different command modes (User EXEC, Privileged EXEC) and their functionalities.
Covers terminal settings like length, monitor, and width for optimal CLI interaction.
Configures the primary, secondary, and tertiary CAPWAP controllers for the access point.
Configures the authentication token for CAPWAP communication.
Erases CAPWAP configuration, with options for full or static IP erasure.
Configures static IP address and DNS settings for the CAPWAP access point.
Configures the operational mode of the access point (e.g., bridge, local).
Clears Cisco TrustSec Security counters and statistics.
Configures client trace functionality on the access point.
Sets filters for client trace to specify what data to capture.
Filters SGACL enforcement debugs based on host IP addresses.
Filters SGACL enforcement debugs by source or destination group tags.
Enables debugging of ARP errors, events, or packets.
Enables debugging of Bluetooth Low Energy (BLE) events and data.
Enables debugging of CAPWAP client activities.
Enables debugging of CAPWAP client AVC (Application Visibility and Control) features.
Configures debugging for CleanAir features and events.
Enables debugging of 802.11 critical, error, event, or information levels.
Enables debugging of 802.11 client datapath for ARP, DHCP, or EAPOL.
Configures 802.11 client debugging levels (critical, error, event, info).
Enables debugging for 802.11 drivers on specific radio slots.
Enables debugging for various FlexConnect features.
Configures debugging for mesh network features.
Enables debugging for Radio Resource Management (RRM) neighbor transmissions or receptions.
Enables debugging for Wireless Intrusion Prevention System (WIPS) errors or events.
Enables debugging for FlexConnect radio interface authentication modules.
Enables client trace debugging for all clients or specific MAC addresses.
Displays the status and details of AP client trace configurations.
Displays CAPWAP client, IP, location, multicast, or traffic information.
Displays detailed CAPWAP client information like call info, config, or traffic.
Displays CAPWAP client trace status, enabling or disabling trace.
Displays 802.11 radio interface status and configuration details.
Displays FlexConnect information for access points.
Displays 802.11 radio interface status and configuration.
Displays memory usage details for processes running on the access point.
Displays Radio Resource Management (RRM) properties like hyperlocation and neighbors.
Displays rogue AP containment information and statistics.
Displays RRM rogue detection configuration parameters and statistics.
Displays the currently running configuration of the access point.
Configures the AP type, such as CAPWAP or Mobility Express.
Halts or reboots the access point, with options for scheduled reloads.
To Next Page