Cisco Aironet Wave 2 User Manual

show running-config
To display the contents of the currently running configuration on the access point, use the show running-config
command.
show running-config
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
The following example shows how to view the contents of the currently running configuration on
the access point:
cisco-wave2-ap# show running-config
AP Name : ap1540
Admin State : Enabled
AP Mode : Local
AP Submode : None
Location : default location
Reboot Reason : Config Mwar
Primary controller name : cisco_3504
Primary controller IP : <controller-ip-address>
Secondary controller name :
Secondary controller IP :
Tertiary controller name :
Tertiary controller IP :
Controller from DHCP offer : <controller-dhcp-server-address>
Controller from DNS server : <controller-dns-server-address>
AP join priority : 1
IP Prefer-mode : IPv4
CAPWAP UDP-Lite : Unconfigured
Last Joined Controller name: wlc3504
DTLS Encryption State : Disabled
Discovery Timer : 10
Heartbeat Timer : 30
CDP State : Enabled
Watchdog monitoring : Enabled
IOX : Disabled
RRM State : Enabled
LSC State : Disabled
SSH State : Enabled
AP Username : admin
Session Timeout : 0
Extlog Host : 0.0.0.0
Extlog Flags : 0
Extlog Status Interval : 0
Syslog Host : <syslog-host-ip-address>
Syslog Facility : 0
Syslog Level : errors
Core Dump TFTP IP Addr :
Core Dump File Compression : Disabled
Core Dump Filename :
Client Trace Status : Enabled(All)
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
130
show Commands
show running-config

Cisco Aironet Wave 2 Specifications

General

Brand	Cisco
Model	Aironet Wave 2
Category	Wireless Access Point
Language	English