Cisco Aironet Wave 2 - Config Boot Debug-Memory

config boot debug-memory
To enable memory debug, use the config boot debug-memory command.
config boot debug-memory {enable |disable}
Syntax Description
Enables memory debugenable
Disables memory
debug
disable
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
This example shows you how to enable memory debug:
cisco-wave2-ap# config boot debug-memory enable
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
35
config Commands
config boot debug-memory