Cisco Aironet Wave 2 User Manual

Understanding CLI Error Messages
This table lists some error messages that you might encounter while using the CLI to configure your AP.
Table 2: Common CLI Error Messages
How to Get HelpMeaningError Message
Enter the command again followed by a question
mark (?) with a space between the command and
the question mark.
The possible keywords that you can enter with the
command appear.
You did not enter enough
characters for your AP to
recognize the command.
% Ambiguous
command: "show
con"
Enter the command again followed by a question
mark (?) with a space between the command and
the question mark.
The possible keywords that you can enter with the
command appear.
You did not enter all the
keywords or values required by
this command.
% Incomplete
command.
Enter a question mark (?) to display all the
commands that are available in this command mode.
The possible keywords that you can enter with the
command appear.
You entered the command
incorrectly. The caret (^) marks
the point of the error.
% Invalid input
detected at ‘^’
marker.
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
5
Using the Command Line Interface
Understanding CLI Error Messages

Cisco Aironet Wave 2 Specifications

General

Brand	Cisco
Model	Aironet Wave 2
Category	Wireless Access Point
Language	English