Cisco Aironet Wave 2 - debug rrm neighbor

debug rrm neighbor
To enable RRM neighbor debugging, use the debug rrm neighbor command.
debug rrm neighbor {tx | rx | detail }
Syntax Description
Enable RRM neighbor Tx debuggingtx
Enable RRM neighbor Rx debuggingrx
Enable RRM neighbor detail debuggingdetail
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of RRM neighbor transmissions:
cisco-wave2-ap# debug rrm neighbor tx
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
68
debug Commands
debug rrm neighbor