Cisco Aironet Wave 2 - Configuring the Terminal

Configuring the Terminal
Before you begin
Enter the Privileged EXEC mode.
Procedure
• Configure the number of lines on the screen by entering this command:
terminal length number-of-lines
Valid range is 0 to 512. If you enter 0, there will be no pausing.
Example:
cisco-wave2-ap# terminal length 20
• Copy debug output to the current terminal line by entering this command:
terminal monitor
• Disable logging to the current terminal line by entering this command:
terminal monitor disable
• Specify the terminal type by entering this command:
terminal type type-name
• Configure the number of characters that should be displayed on a screen line by entering this command:
terminal width number-of-characters
Valid range is 0 to 132.
Example:
cisco-wave2-ap# terminal width 30
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
6
Using the Command Line Interface
Configuring the Terminal