Cisco Aironet Wave 2 - debug flexconnect

debug flexconnect
To debug FlexConnect features, use the debug flexconnect command.
debug flexconnect {acl | cckm | dot11r | event | multicast {igmp | traffic} | pmk |
proxy-arp | vsa | wlan-vlan | wsastats}
Syntax Description
Configures debugging of FlexConnect ACLacl
Configures debugging of CCKMcckm
Configures debugging of 802.11rdot11r
Configures debugging of wireless control protocol (WCP) eventsevent
Configures debugging of Multicast IGMPmulticast igmp
Configures debugging of Multicast trafficmulticast traffic
Configures debugging of opportunistic key caching (OKC) or pairwise master key cachingpmk
Configures debugging of AAA vendor specific attributes (VSA)vsa
Configures debugging of WLAN-VLAN mappingwlan-vlan
Configures debugging of RADIUS or DHCP wireless service assurance statisticswsastats
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of FlexConnect ACL:
cisco-wave2-ap# debug flexconnect acl
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
59
debug Commands
debug flexconnect