Cisco Aironet Wave 2 - debug dot11

debug dot11
To enable debugging of 802.11, use the debug dot11 command.
debug dot11 {critical | errors | events | info}
Syntax Description
Enables 802.11 critical level debuggingcritical
Enables 802.11 error level debuggingerrors
Enables 802.11 event level debuggingevents
Enables 802.11 information level debugginginfo
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of 802.11 error level:
cisco-wave2-ap# debug dot11 errors
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
52
debug Commands
debug dot11