Cisco Aironet Wave 2 - debug dhcp

debug dhcp
To configure debugging of DHCP, use the debug dhcp command.
debug dhcp {errors | events | packets}
Syntax Description
Enables debugging of DHCP errorserrors
Enables debugging of DHCP eventsevents
Enables debugging of DHCP packetspackets
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of DHCP errors:
cisco-wave2-ap# debug dhcp errors
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
51
debug Commands
debug dhcp