Cisco Aironet Wave 2 - copy

copy
To copy a file, use the copy command.
copy {cores filename [scp: scp-url | tftp: tftp-url] | flash filename [scp: scp-url | tftp:
tftp-url] | support-bundle [scp: scp-url | tftp: tftp-url] | syslogs [filename {scp: scp-url |
tftp: tftp-url} | scp: scp-url | tftp: tftp-url]}
Syntax Description
Applies the action on a core filecores
Name of the file
filename
Uses the SCP protocolscp:
Enter the SCP URL in the following format:
username@A.B.C.D:[/dir]/filename
scp-url
Uses the TFTP protocoltftp:
Enter the TFTP URL in the following format:
A.B.C.D[/dir]/filename
tftp-url
Applies the action on a flash fileflash
Copies the support bundle to the serversupport-bundle
Applies the action on the syslog filesyslogs
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
144
System Management Commands
copy