Cisco Aironet Wave 2 - show rrm rogue detection

show rrm rogue detection
To view RRM rogue detection configuration parameters, use the show rrm rogue detection command.
show rrm rogue detection {adhoc |ap |clients |config |rx-stats} Dot11Radio radio-interface-number
Syntax Description
Displays the master adhoc rogue AP list for a 802.11 radio slot; valid values are 0
and 1
adhoc
Displays rogue detection parameters for the AP for a 802.11 radio slot; valid values
are 0 and 1
ap
Displays master list of rogue clientsclients
Displays rogue detection configuration on the APconfig
Displays rogue detection receive statistics on the 802.11 interfaces of an APrx-stats
Specifies 802.11 radio interefaceDot11Radio
The 802.11 radio interface number; valid values are 0 and 1
radio-interface-number
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
The following example shows how to view the RRM rogue detection configuration details:
cisco-wave2-ap# show rrm rogue detection config
Rogue Detection Configuration for Slot 0:
Rogue Detection Mode : Enabled
Rogue Detection Report Interval : 10
Rogue Detection Minimum Rssi : -90
Rogue Detection Transient Interval : 0
Rogue Detection Flex Contain : Disabled
Rogue Detection Flex Contain Adhoc : Disabled
Rogue Detection Flex Contain SSID : Disabled
Rogue Containment Autorate : Disabled
Scan Duration : 180000
Channel Count : 11
Transient Threshold : 0
Rogue Detection Configuration for Slot 1:
Rogue Detection Mode : Enabled
Rogue Detection Report Interval : 10
Rogue Detection Minimum Rssi : -90
Rogue Detection Transient Interval : 0
Rogue Detection Flex Contain : Disabled
Rogue Detection Flex Contain Adhoc : Disabled
Rogue Detection Flex Contain SSID : Disabled
Rogue Containment Autorate : Disabled
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
128
show Commands
show rrm rogue detection