show flexconnect wlan
To view the WLAN configuration for Flexconnect AP mode, use the show flexconnect wlan command.
show flexconnect wlan [{l2acl |qos |vlan}]
Syntax Description
Specifies the Layer 2 ACL mapping for WLANl2acl
Specifies the QoS parameters for WLANqos
Specifies the VLAN mapping for WLANvlan
Command Modes
User EXEC (>)
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
The following example shows how to view the WLAN Layer 2 ACL mapping for the Flexconnect
AP:
cisco-wave2-ap# show flexconnect wlan l2acl
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
112
show Commands
show flexconnect wlan
To Next Page
Loading...
