Cisco Aironet Wave 2 - config ap client-trace filter

config ap client-trace filter
To set filters for client trace, use the config ap client-trace filter command.
config ap client-trace filter {all[disable | enable] | arp[disable | enable] | assoc[disable
| enable] | auth[disable | enable] | dhcp[disable | enable] | eap[disable | enable] |
icmp[disable | enable] | ndp[disable | enable] | probe[disable | enable]}
Syntax Description
Trace all filtersall
Trace ARP packetsarp
Trace ASSOC
packets
assoc
Trace auth packetsauth
Trace DHCP packetsdhcp
Trace EAP packetseap
Trace ICMP packetsicmp
Trace NDP Packetsndp
Trace probe packetsprobe
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
To set filters for client trace, use this command:
cisco-wave2-ap# config ap client-trace filter
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
30
config Commands
config ap client-trace filter