Cisco Aironet Wave 2 - debug cdp

debug cdp
To enable debugging of controller discovery protocol (CDP), use the debug cdp command.
debug cdp {adjacency | events | ilp | packets}
Syntax Description
Enables debugging of CDP neighborsadjacency
Enables debugging of CDP eventsevents
Enables debugging of inline powerilp
Enables debugging of CDP packetspackets
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of CDP events:
cisco-wave2-ap# debug cdp events
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
49
debug Commands
debug cdp