Cisco Aironet Wave 2 - capwap ap ethernet

capwap ap ethernet
To configure AP Ethernet parameters, use the capwap ap ethernet command.
capwap ap ethernet tag ethernet-vlan-id
Syntax Description
Ethernet VLAN ID; valid range is 0 to 4094. If you enter the VLAN ID value as 0, the
VLAN tagging is disabled.
ethernet-vlan-id
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to configure Ethernet VLAN tagging on the AP:
cisco-wave2-ap# capwap ap ethernet tag 2
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
13
capwap Commands
capwap ap ethernet