Cisco Aironet Wave 2 - Config Boot Baudrate

config boot baudrate
To set the baud rate, use the config boot baudrate command.
config boot baudrate {115200 | 9600}
Syntax Description
Sets the baud rate to
115200
115200
Sets the baud rate to 9600
9600
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to configure the baud rate to 9600:
cisco-wave2-ap# config boot baudrate 9600
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
32
config Commands
config boot baudrate