Cisco Aironet Wave 2 - show ip

show ip
To view the IP information, use the show ip command.
show ip {access-lists | interface brief | route | tunnel [eogre {domain | forwarding-table
| gateway} | fabric | summary]}
Syntax Description
Lists the IP access listsaccess-lists
Displays the IP interface status and configurationinterface
Displays the brief summary of IP status and configurationbrief
Displays the IP routing tableroute
Displays the IP tunnel informationtunnel
Displays the EoGRE tunnel informationeogre
Displays the EoGRE tunnel domain informationdomain
Displays the EoGRE tunnel encapsulation and decapsulation informationforwarding-table
Displays the EoGRE tunnel gateway informationgateway
Displays the IP fabric tunnel informationfabric
Displays the information for all tunnelssummary
Command Modes
User EXEC (>)
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
The following example shows how to view information about the lists the IP access lists:
cisco-wave2-ap# show ip access-lists
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
117
show Commands
show ip