Cisco Aironet Wave 2 - debug ble

debug ble
To enable debugging of Bluetooth Low Energy (BLE), use the debug ble command.
debug ble {critical |error |events |fastpath {rssi |scan |sync} |receive |transmit}
Syntax Description
Enables debugging of BLE critical eventscritical
Enables debugging of BLE error eventserror
Enables debugging of BLE eventsevents
Shows data exported to CMX. The following options are available:
• RSSI data
• Scan data
• Sync data
fastpath {rssi | scan | sync}
Enables debugging of BLE packet received from BLE radioreceive
Enables debugging of BLE packet transmitted to BLE radiotransmit
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.7
Examples
The following example shows how to enable debugging of BLE critical events:
cisco-wave2-ap# debug ble critical
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
46
debug Commands
debug ble