Cisco Aironet Wave 2 - debug sip

debug sip
To enable session initiation protocol (SIP) debugging, use the debug sip command.
debug sip {all | tx | rx}
Syntax Description
Enabling SIP transmission and reception debuggingall
Enabling SIP transmission debuggingtx
Enabling SIP reception debuggingrx
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of SIP transmissions and reception:
cisco-wave2-ap# debug sip all
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
70
debug Commands
debug sip