config cts debug enforcement protocol
To filter SGACL enforcement debugs based on protocol, use the config cts debug enforcement protocol
command.
config cts debug enforcement protocol {protocol-id | icmp | tcp | udp}
Syntax Description
Protocol ID; valid values are between 0 to 65535
protocol-id
Filter SGACL enforcement for ICMP trafficicmp
Filter SGACL enforcement for TCP traffictcp
Filter SGACL enforcement for UDP trafficudp
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
The following example shows you how to filter SGACL enforcement debugs based on protocol for
UDP traffic:
cisco-wave2-ap# config cts debug enforcement protocol udp
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
41
config Commands
config cts debug enforcement protocol
To Next Page
Loading...
