Cisco Aironet Wave 2 - config cts debug enforcement permissions

config cts debug enforcement permissions
To filter SGACL enforcement debugs based on source group tag (SGT) and destination group tag (DGT), use
the config cts debug enforcement permissions command.
config cts debug enforcement permissions {dgt | sgt} tag-id
Syntax Description
Destination group tagdgt
Source group tagsgt
Tag identifier; valid values are beteween 0 to 65535
tag-id
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
The following example shows you how to filter SGACL enforcement debugs for a destination group
tag whose ID is 600:
cisco-wave2-ap# config cts debug enforcement permissions dgt 600
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
40
config Commands
config cts debug enforcement permissions