debug mesh adjacency
To debug mesh adjacency, use the debug mesh adjacency command.
debug mesh adjacency {child |clear |dfs |message |packet |parent }
Syntax Description
Debug mesh adjacencyadjacency
Debug mesh adjacency childchild
Debug clear mesh adjacencyclear
Debug mesh DFSdfs
Debug mesh adjacency messagesmessage
Debug mesh adjacency packetpacket
Debug mesh adjacency parentparent
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of mesh adjacency parent:
cisco-wave2-ap# debug mesh adjacency parent
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
66
debug Commands
debug mesh adjacency