config cts debug enforcement host_ip
To filter the SGACL enforcement debugs based on the host IP, use the config cts debug enforcement host_ip
command.
config cts debug enforcement host_ip {ipv4 dst-ip [src-ip] | ipv6 dst-ip [src-ip]}
Syntax Description
Displays only the IPv4 SGACL enforcement debugs based on the destination and,
optionally, source IP addresses
ipv4 dst-ip [src-ip]
Displays only the IPv6 SGACL enforcement debugs based on the destination and,
optionally, source IP addresses
ipv6 dst-ip [src-ip]
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
The following example shows you how to filter the IPv4 SGACL enforcement debugs based on the
host IP:
cisco-wave2-ap# config cts debug enforcement host_ip ipv4 209.165.200.224 209.165.200.227
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
38
config Commands
config cts debug enforcement host_ip
To Next Page
Loading...
