Cisco Aironet Wave 2 - debug dtls client

debug dtls client
To configure DTLS client error and event debugging, use the debug dtls client command.
debug dtls client {error | event [detail]}
Syntax Description
Configures debugging of DTLS client errorserror
Configures debugging of DTLS client eventsevent [detail]
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of DTLS client events:
cisco-wave2-ap# debug dtls client event
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
57
debug Commands
debug dtls client