Cisco Aironet Wave 2 - debug authentication interface

debug authentication interface
To enable FlexConnect radio interface debugging, use the debug authentication interface command.
debug authentication interface interface-name {all | dot11 | dot1x | driver | others | radius | wpa}
Syntax Description
Name of the interface to debug
interface-name
Enable all parts debuggingall
Enable 802.11 module debuggingdot11
Enable 802.1x module debuggingdot1x
Enable driver module debuggingdriver
Enable other non-module parts debuggingothers
Enable RADIUS module debuggingradius
Enable WPA module debuggingwpa
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of WPA module:
cisco-wave2-ap# debug authentication interface management wpa
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
72
debug Commands
debug authentication interface