Cisco Aironet Wave 2 User Manual

debug client trace
To enable client trace debugging, use the debug client trace command.
debug client trace {all |address mac-address |enable |filter {assoc | auth | dhcp | eap | icmp | mgmt |
probe | proto}}
Syntax Description
Configure all clients tracingall
Configure address(es) to traceaddress
MAC address to trace
mac-address
Enable tracingenable
Configure trace filterfilter
Trace Association packetsassoc
Trace Authentication packetsauth
Trace DHCP packetsdhcp
Trace EAP packetseap
Trace ICMP packetsicmp
Trace probe, assoc, auth, EAP packetsmgmt
Trace probe packetsprobe
Trace DHCP, ICMP packetsproto
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable tracing of all clients:
cisco-wave2-ap# debug client trace all
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
76
debug Commands
debug client trace

Cisco Aironet Wave 2 Specifications

General

Brand	Cisco
Model	Aironet Wave 2
Category	Wireless Access Point
Language	English