debug ethernet
To configure Ethernet debugging, use the debug ethernet command.
debug ethernet interface-number {both | rcv | xmt}
Syntax Description
Interface number that you have to enter as either 0 or
1
interface-number
Enables debugging of both transmission and receptionboth
Enables debugging of receptionrcv
Enables debugging of transmissionxmt
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of transmission for interface 0:
cisco-wave2-ap# debug ethernet 0 xmt
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
58
debug Commands
debug ethernet
To Next Page
Loading...
