Cisco Aironet Wave 2 - Config Boot Path

config boot path
To configure the boot path, use the config boot path command.
config boot path {1 | 2}
Syntax Description
Path to be specified as Part 1 or Part
2
{1 | 2}
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to configure the booth path as 1:
cisco-wave2-ap# config boot path 1
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
37
config Commands
config boot path