Cisco Aironet Wave 2 - show avc status

show avc status
To list the AVC provisioning status per WLAN/VAP, use the show avc status command.
show avc status
Command Modes
User EXEC (>)
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
The following example shows how to view AVC provisioning status per WLAN/VAP:
cisco-wave2-ap# show avc status
VAP FNF-STATUS AVC-QOS-STATUS
0 Disabled Disabled
1 Disabled Disabled
2 Disabled Disabled
3 Disabled Disabled
4 Disabled Disabled
5 Disabled Disabled
6 Disabled Disabled
7 Disabled Disabled
8 Disabled Disabled
9 Disabled Disabled
10 Disabled Disabled
11 Disabled Disabled
12 Disabled Disabled
13 Disabled Disabled
14 Disabled Disabled
15 Disabled Disabled
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
88
show Commands
show avc status