EasyManuals Logo

Cisco Aironet Wave 2 User Manual

Cisco Aironet Wave 2
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
debug tunnel
To configure debugging of tunnel, use the debug tunnel command.
debug tunnel eogre
Syntax Description
Configures debugging of EoGRE tunneleogre
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of EoGRE tunnel:
cisco-wave2-ap# debug tunnel eogre
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
75
debug Commands
debug tunnel

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Aironet Wave 2 and is the answer not in the manual?

Cisco Aironet Wave 2 Specifications

General IconGeneral
CategoryWireless Access Point
Wireless Standard802.11ac Wave 2
ModelAironet Wave 2
Frequency Bands2.4 GHz, 5 GHz
Maximum Data Rate1.7 Gbps
MIMO TechnologyMU-MIMO
MIMO4x4:4
Power over EthernetYes (802.3af/at)
SecurityWPA2, WPA3, 802.1X, AES, TKIP
ManagementCisco DNA Center, Cisco Prime Infrastructure, WebUI, CLI
Operating Temperature0 to 40°C (32 to 104°F)
MountingCeiling, wall, pole

Related product manuals