Cisco Aironet Wave 2 - debug dot11 client datapath

debug dot11 client datapath
To enable debugging of 802.11 client datapath, use the debug dot11 client datapath command.
debug dot11 client datapath {{arp | dhcp | eapol} {addr {mac-addr1 | mac-addr2 | mac-addr3
| mac-addr4} | all}} | dns-acl}
Syntax Description
Enables client datapath ARP debuggingarp
Enables client datapath DHCP debuggingdhcp
Enables client datapath EAPOL debuggingeapol
Option to specify MAC address of specific clients or all clients{addr | all}
MAC addresses of clients that you have to enter
{mac-addr1 | mac-addr2 | mac-addr3
| mac-addr4}
Enables client datapath DNS-ACL debuggingdns-acl
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of client datapath ARP:
cisco-wave2-ap# debug dot11 client datapath arp
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
53
debug Commands
debug dot11 client datapath