To Next PageTo Next PageHow to fix Cisco Wireless Access Point not communicating with client devices?
If your Cisco Wireless Access Point isn't communicating with client devices, the issue might be due to mismatched basic settings. Ensure that the SSID and WEP settings on the access point match those on the client devices.
What to do if Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP has a corrupt firmware image?
If your Cisco Wireless Access Point has a corrupt firmware image, indicated by three red LEDs, reload the image from a connected TFTP server.
What to do if Cisco AIR-AP1230B-A-K9 - Syst. 1230 Aironet WLAN AP firmware failure?
In case of a firmware failure on your Cisco Wireless Access Point, reload the complete access point image file using the Web browser interface or by pressing and holding the MODE button.
How to upgrade firmware image on Cisco Wireless Access Point?
If the firmware on your Cisco Wireless Access Point is operational but you want to upgrade it, use the Web browser interface to reload the access point image file.
General| Model | AIR-AP1230B-A-K9 |
|---|---|
| Category | Wireless Access Point |
| Frequency Band | 2.4 GHz |
| Power over Ethernet (PoE) | Yes |
| Wireless Standards | IEEE 802.11b |
| Maximum Data Rate | 54 Mbps |
| Ethernet Ports | 1 x 10/100Base-TX |
| Antenna Type | External |
| Weight | 1.5 lbs |
| Form Factor | External |
| Data Link Protocol | IEEE 802.11b |
| Compliant Standards | IEEE 802.3, IEEE 802.3u |
| Data Rates | 11 Mbps |
| Power Supply | PoE |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Humidity | 10 - 95% (non-condensing) |
