Cisco Aironet Wave 2 - debug dot11 driver slot

debug dot11 driver slot
To enable debugging of 802.11 drivers, use the debug dot11 driver slot command.
debug dot11 driver slot {0 | 1} {all | {cac {info | metrics}} | chd | save-acnt-data |
save-on-failure [extended] | stop-on-failure | tsm | vim}
Syntax Description
Enables 802.11 driver debugs per radio
slot {0 | 1}
Enables all 802.11 driver debugsall
Enables 802.11 CAC debugscac
Enables 802.11 CAC info level debugscac info
Enables debugging of 802.11 CAC metricscac metrics
Enables 802.11 CHD debugschd
Saves the radio accounting datasave-acnt-data
Saves the radio crash information upon radio failuresave-on-failure
Saves extended information on radio failuresave-on-failure extended
Stops the AP from reboot on radio failurestop-on-failure
Enables 802.11 traffic stream metric debugstsm
Enables 802.11 video metric debugsvim
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of CAC at the information level:
cisco-wave2-ap# debug dot11 driver slot cac info
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
55
debug Commands
debug dot11 driver slot