Cisco Aironet Wave 2 - Config Boot Manual

config boot manual
To enable manual boot of the AP, use the config boot manual command.
config boot manual {enable | disable}
Syntax Description
Enables manual bootenable
Disables manual
boot
disable
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable manual boot:
cisco-wave2-ap# config boot manual enable
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
36
config Commands
config boot manual