Cisco Aironet Wave 2 - debug mesh path-control

debug mesh path-control
To configure debugging of mesh path control, use the debug mesh path-control command.
debug mesh path-control {error |events |packets }
Syntax Description
Configures debugging of mesh path control errorserror
Configures debugging of mesh path control eventsevents
Configures debugging of mesh path control packetspackets
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of mesh path control errors:
cisco-wave2-ap# debug mesh path-control error
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
67
debug Commands
debug mesh path-control