Cisco Aironet Wave 2 - debug mesh

debug mesh
To configure debugging of mesh networks, use the debug mesh command.
debug mesh {channel |clear |convergence |events |forward-mcast |forward-packet |forward-table
|linktest |path-control |port-control |security |trace}
Syntax Description
Configures debugging of mesh channelchannel
Resets all mesh debugsclear
Configures debugging of mesh convergenceconvergence
Configures debugging of mesh eventsevents
Configures debugging of mesh forwarding Multicastforward-mcast
Configures debugging of mesh forwarding packetsforward-packet
Configures debugging of mesh forwarding tableforward-table
Configures debugging of mesh linktestlinktest
Configures debugging of mesh port controlport-control
Configures debugging of mesh securitysecurity
Configures debugging of mesh tracetrace
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable debugging of mesh channel:
cisco-wave2-ap# debug mesh channel
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
65
debug Commands
debug mesh