Cisco Aironet Wave 2 - Config Boot Break

config boot break
To enable break, use the config boot break command.
config boot break {enable | disable}
Syntax Description
Enables boot breakenable
Disables boot
break
disable
Command Modes
Privileged EXEC (#)
Command History
ModificationRelease
This command was
introduced.
8.1.111.0
Examples
The following example shows how to enable boot break:
cisco-wave2-ap# config boot break enable
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
33
config Commands
config boot break