Cisco Aironet Wave 2 - Using the Command Line Interface

Using the Command Line Interface
This chapter describes the Cisco Aironet Wave 2 AP command-line interface (CLI) and how to use it to
configure your AP.
• Understanding Command Modes, on page 2
• Understanding Abbreviated Commands, on page 3
• Understanding no Forms of Commands, on page 4
• Understanding CLI Error Messages, on page 5
• Configuring the Terminal, on page 6
• Recalling Commands, on page 7
• Accessing the CLI, on page 8
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
1