Cisco Aironet Wave 2 - config ap client-trace

config ap client-trace
To configure client trace on the access point, use the config ap client-trace command.
config ap client-trace {address {add|clear-all|delete}|all-clients {enable|disable}|filter {all
{enable|disable}|arp {enable|disable}|assoc {enable|disable}|auth {enable|disable}|dhcp
{enable|disable}|eap {enable|disable}|icmp {enable|disable}|ndp {enable|disable}|probe
{enable|disable}}|inline-mon {enable|disable}|output console-log|start|stop}
Syntax Description
Configure clients to trace. Specify the MAC address of the clientaddresses
Specifies a client to traceadd
Delete all client traces on this access pointclear-all
Deletes client address to be traced. Takes a client MAC addressdelete
Trace all clientsall-clients
Enables trace for all clientsenable
Disables trace for all clientsdisable
Sets filters for cleint tracingfilter
Traces all filtersall
Traces ARP packets
Use the enable or disable keyword to enable or disable this filter.
arp
Traces ASSOC packetsassoc
Traces auth packetsauth
Traces DHCP packetsdhcp
Traces EAP packetseap
Traces ICMP packetsicmp
Traces NDP packetsndp
Trace probe packets.probe
Enables or disables inline monitoringinline-mon
Enables or disables logging to the console or log fileoutput
Specifies console log keyword
console-log
Starts client tracingstart
Stops client trackingstop
Cisco Aironet Wave 2 Access Point Command Reference, Release 8.7
28
config Commands
config ap client-trace